TRIGA Install Instructions

Installing your TRIGA

  1. TRIGA plates have extremely tight tolerances
  2. Yours may require minor fitment
  3. Remove Optic Screws from posts
  4. Insert front nose of TRIGA into MOS
  5. Use consistent pressure seat the rear
  6. Ensure plate is flat on slide prior to mounting screws
  7. Apply MINIMAL Blue Loctite on each screw
  8. Hand tighten silver Sealing Screw do not OVERTIGHTEN
  9. Mount Optic ensuring base is fully seated
  10. Tighten black Optic Screws to 10” lbs.